BWTHG - 340HP URETHANE CATALYST-EXTERIOR
- MSDS: BWTHG
- Manufacturer: CARDINAL INDUSTRIAL FINISHES
- Product Name: 340HP URETHANE CATALYST-EXTERIOR
- National Stock Number: 8010-00F019689
Product Identification
Product ID:340HP URETHANE CATALYST-EXTERIOR
MSDS Date:10/04/1994
FSC:8010
NIIN:00F019689
MSDS Number: BWTHG
Responsible Party
SOUTH EL MONTE, CA 91733-3012
US
Emergency Phone: 800-444-9274/213-283-9335
Info Phone: 818-444-9274/213-283-9335
Preparer: BOB SYPOWICZ
Cage: 65860
Contractor
Telephone: 818-444-9274 OR 213-283-9335
Cage: 65860
Ingredients
BUTYL ACETATE (N-BUTYL ACETATE) *95-1*
CAS: 123-86-4
RTECS: AF7350000
Fraction By Weight: 10%
OSHA PEL 710 MG/CUM
ACGIH TLV: 713 MG/CUM
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
HEXAMETHYLENE DIISOCYANATE
CAS: 822-06-0
RTECS: MO1740000
Fraction By Weight: <0.2%
ACGIH TLV: 0.005 PPM
EPA Report Quantity: 1 LB
DOT Report Quantity: 1 LB
0.93/GAL 112 GRAMS/LITER
RTECS: 9999999VO
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:EYES: IRRITATION. SKIN: MODERATE
IRRITATION/DERMATITIS. INHALATION: NASAL IRRITATION. INGESTION:
GASTROINTESTINAL IRRITATION. ALLERGIC SKIN/RESPIRATORY REACTION MAY
OCCUR IN SOME INDIVIDUALS. PAINT & SOLVENTS HAVE BEEN LINKED TO
LIVER ABNORMALITIES, KIDNEY & LUNG DAMAGE.
Explanation of Carcinogenicity:SEE INGREDIENTS. ACCORDING TO CARDINAL
INDUSTRIAL FINISHES, TOLUENE DIISOCYANATE IS SUSP. CARC BY OSHA,
NTP.
Effects of Overexposure:IRRITATION, REDNESS, TEARING, BLURRED VISION,
DEFATTING, HEADACHE, DIZZINESS, NAUSEA, WEAKNESS, VOMITING, LOSS OF
CONSCIOUSNESS, RASH, ITCHING, HIVES, SWELLING OF EXTREMITIES,
ASTHMA-LIKE SYMPTOMS
Medical Cond Aggravated by Exposure:PRE-EXISTING RESPIRATORY
CONDITIONS. PRE-EXISTING SKIN, LIVER & KIDNEY DISORDERS
First Aid
First Aid:EYES: FLUSH W/WATER FOR 15 MINS. SKIN: WASH W/SOAP & WATER.
INHALATION: REMOVE TO FRESH AIR. GIVE OXYGEN/CPR IF NECESSARY.
INGESTION: DON'T INDUCE VOMITING, KEEP WARM & QUIET. OBTAIN MEDICAL
ATTENTION IN ALL CASES.
Fire Fighting
Flash Point Method:TCC
Flash Point:72F
Lower Limits:1.7
Upper Limits:7.6
Extinguishing Media:FOAM, DRY CHEMICAL, CO2, WATER FOG
Fire Fighting Procedures:USE SELF CONTAINED BREATHING APPARATUS W/FULL
FACEPIECE OPERATED IN A PRESSURE DEMAND/OTHER POSITIVE PRESSURE
MODE.
Unusual Fire/Explosion Hazard:FLAMMABLE LIQUID. CONTAINERS MAY
DEFORM/EXPLODE WHEN EXPOSED TO EXTREME HEAT.
Accidental Release
Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES, ABSORB LIQUID
IN ABSORBANT MATERIAL & PREVENT SPREADING TO GROUND WATER.
Handling
Handling and Storage Precautions:CONTAINERS OF THIS MATERIAL MAY BE
HAZARDOUS WHEN EMPTIED, SINCE EMPTIED CONTAINERS RETAIN PRODUCT
RESIDUALS. OBSERVE ALL HAZARDOUS PRECAUTIONS.
Other Precautions:FOR INDUSTRIAL USE ONLY. USE ONLY W/ADEQUATE
VENTILATION.
Exposure Controls
Respiratory Protection:IF TLV OF THE PRODUCT/ANY COMPONENT IS EXCEEDED,
A NIOSH/MSHA JOINTLY APPROVED AIR SUPPLIED RESPIRATOR IS ADVISED IN
ABSENCE OF ENVIRONMENTAL CONTROL. AIR SUPPLY RESPIRATORS ARE
SUGGESTED FOR SPRAY AP PLICATION.
Ventilation:SUFFICIENT MECHANICAL (GENERAL/LOCAL EXHAUST) TO MAINTAIN
EXPOSURE BELOW TLVS
Protective Gloves:CHEMICAL/SOLVENT RESISTANT
Eye Protection:OSHA APPROVED CHEMICAL
Other Protective Equipment:SPLASH APRON, IMPERVIOUS CLOTHING, CHEMICAL
RESISTANT BOOTS, GB PROTECTIVE HAND CREAM
Work Hygienic Practices:REMOVE/LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE. WASH HANDS BEFORE EATING/USING REST ROOM, SMOKE IN SMOKING
AREAS ONLY
Supplemental Safety and Health
Chemical Properties
HCC:F3
Boiling Pt:B.P. Text:171-302F
Vapor Density:>1
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:12.8
Stability
Stability Indicator/Materials to Avoid:YES
WATER, ALCOHOLS, AMINES, ALKALIS & STRONG OXIDIZING AGENTS
Stability Condition to Avoid:EXTREME TEMPS, MOISTURE
Hazardous Decomposition Products:OXIDES OF CARBON & NITROGEN, TRACES OF
HYDROGEN CYANIDE, TOLUENE DIISOCYANATE, CO, CO2
Conditions to Avoid Polymerization:WATER, ALCOHOLS, & AMINES
Disposal
Waste Disposal Methods:DESTROY BY INCINERATION. CONTAMINATED ABSORBENT
SHOULD BE INCINERATED/SENT TO APPROVED LANDFILL IN ACCORDANCE
W/LOCAL, STATE & FEDERAL REGULATIONS. FLAMMABLE LIQUID UN1263.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.